CURRENCY     (Info?)
|
 
  Matho Models
You are here: Catalogue > Accessories > 3D Print > 35047
 
 
 
CatsCatsCats
CatsCatsCats
CatsCatsCats
   

Matho Models 35047 Cats

    4 review(s) | Add your Review
 
€15.95 (€13.18 ex. VAT)
Currently not available
Expected back: unknown
 
ADD TO WISHLIST
TELL A FRIEND

Product Availability

 
see information above.
Product may still be available at our dealers.

What are the shipping costs?

An overview of the shipping costs can be found here.

Do you ship to my country?

We ship worldwide, so yes, we do ship to your country!

How can I pay?

We accept payment via Credit Card, Paypal, Bank Transfer, Bankcontact, iDeal, Sofort Banking or Cash on pickup. More info here.
Product Details
Scale: 1:35
Article code: 35047
Manufacturer: Matho Models
Added on: Thursday 25 August, 2016
Product Description

Contains 5 different types of cats, unpainted, 3D printed in high detail resin.

 

How to work with 3D printed resin parts?

  1. Be carefull when manipulating 3D printed parts, they can be brittle!
  2. Carefully remove the sprue.
  3. Start sanding where needed. The 3D printing process builds up a product in micro-layers. Those layers sometimes remain slightly visible in some areas (especially under magnification), they can be sanded out with a medium sandpaper (like 600 grit), followed by a fine sandpaper (like 1000 grit).
  4. You must apply a primer first before checking if you have sanded enough! Without primer it is hard to check. If needed repeat the process until you are satisfied. 
  5. Now it is ready paint and weather.

 

Tip for sanding very small and difficult areas

Cut a small strip of sandpaper 1 - 2 mm wide, fold it and grab it with a tweezers (not the one with a pointy tip, but the one with a flat 1 - 2mm broad tip). Hold it in such a way that the fold is sticking out for only a tiny fraction (make sure it is the fold that is sticking out, and not the loose ends of the strip). Keep holding the tweezers like that and move over the surface you want to sand. When the sandpaper is clogged, make a new fold in an area of the strip that has not been used before, and continue like before. 

See the image below, it explains it all:


How to sand?
click to enlarge

DID YOU SEE OUR OTHER RECENT RELEASES?
 

Buy more? Save more!
Quick Search
Search
Featured
We also sell on



We Accept



 
   
  © Copyright 2014 - 2024 Matho Models. All Rights Reserved.
Address: Erfgoedlaan 7 - 9800 Deinze - BELGIUM
Tel.: +32 (0) 477 49 13 61 - E-mail: see contact page
website by Matho Graphics  
  All prices shown are including VAT for EU-customers, and excluding VAT for non-EU-customers, unless otherwise stated.